Hello Guest it is May 16, 2021, 03:18:32 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Q_alsayed

Pages: 1
1
General Mach Discussion / Re: i need help in setting up the Mach
« on: September 12, 2011, 08:09:23 AM »
Hi hood
i check the wire it is ok
however, i try some think which i can not find the reason. my existing machine are running by windows 7. i change the machine and try to rub same file with other computer running by windows xp . it run with out problems. and it is old computer.
so how i can check the right computer suitable for the machine and program.


thank you.

2
General Mach Discussion / Re: i need help in setting up the Mach
« on: September 11, 2011, 10:57:21 AM »
Hi
thank you for replay
to Rich
i did no. 1, 2, 3.
the machine is from china. ( working travel  850,480,65.) stepper motor type (57 two phase  3A super-low noise)
spindle motor 0.8 kw  VFD spindle .
spindle speed 3000--9000 rpm
resetting accuracy 0.05


the massage error is external  emergency ...

i increase the Debounce Interval to 1500 but still after some time it is stop.
if i give sample job it is ok but if it is need cutting and pass more then one time i face the problem.

3
General Mach Discussion / i need help in setting up the Mach
« on: September 11, 2011, 06:54:25 AM »
Hi
I need some help. I bought new machine with 3 axis. Also im new in  CNC. I face problem with the setting up my machine. After I start running the program(G code), in the middle the program is stop due to Estope. Is there any part I need to check. I was thinking that happened because I have the free copy. But already I bought the license. 
I appreciate your support.

Pages: 1