Hello Guest it is May 30, 2023, 07:56:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Dan911

Pages: 1
1
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: February 26, 2015, 06:25:20 PM »
sorry never thought to look there.

Thanks!

2
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: February 26, 2015, 09:28:08 AM »
Hi Gerry, was hoping you can help me. I'm setting up my xbox controller and want to use a button for simple auto zero. I used macro M881 and worked but than looks to auto zero on fixed plate. I want the xbox controller button to work the same simple auto zero like on my screenset.

Thanks,
Dan

3
Finished Plugins for Download / Re: Huanyang VFD controller plugin
« on: September 16, 2011, 03:51:57 PM »
Oh sorry, I guess I was lucky to have a serial port on my comp. I think any converter to RS-485 should work like Matty said in the beginning of thread. I suspect the problems some were having with this plugin had nothing to do with which converter they were using or electrical noise.

4
Finished Plugins for Download / Re: Huanyang VFD controller plugin
« on: September 16, 2011, 01:13:00 PM »
Which one did you use and anyone tried this one?
Ebay  280710974429
Nosmo
[/quote]

The link is in post, here it is again.

http://www.ebay.com/itm/190539776031?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649

5
Finished Plugins for Download / Re: Huanyang VFD controller plugin
« on: September 10, 2011, 09:25:44 AM »
I think I discovered what's causing most of the users of this plugin problems. If your at the point where Mach is communicating( pd001=2 pd002=2) with plugin and problems begin with start of spindle, than go to your ports and pins/ inputs and disable( mainly Estop and limit switches or any active high signal Mach is continually searching for) all for testing.

I think most will find everything working without a glitch and this is where the trouble is. If your at this point post back and we can discuss my work around or a possible fix.

Dan

BTW this is the RS-485 converter I'm using, and it cost less than $6.00

http://www.ebay.com/itm/190539776031?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649

6
Finished Plugins for Download / Re: Huanyang VFD controller plugin
« on: September 09, 2011, 06:48:31 AM »
Received my rs-485 converter and was running my spindle through Mach 3 in less than 30 minuets thanks to this thread!!! I came across a few bugs that have to be worked out but spindle on/off and spindle speed works great. Thanks for the great plugin Matty!

Dan

Pages: 1