Messages

1

General Mach Discussion / Re: Digitizing with Mach3 Useing Microkinetics post processor

« on: September 14, 2011, 01:40:59 PM »

I would prefer to use mach3 as controller rather than the Microkinetics which is lacking  many features in there digitizing abilities. thanks

2

General Mach Discussion / Digitizing with Mach3 Useing Microkinetics post processor

« on: September 02, 2011, 11:41:36 AM »

I'm new here looking for input on using Mach3 to digitize small ducts. Does anyone know if Mach3 will work with Microkinetics MN400 Drive Rack system, or a way to use Mach3 along side Microkinetics Millmaster/Multicam ?  Any input will be much appreciated-Mike