1
General Mach Discussion / Re: need tech support will pay.
« on: August 30, 2011, 09:37:16 PM »
Got the machine running! thanks everyone.
Fine tune.
the spindle is still a bit of a problem. I've calibrated with a new pulley to 33,000 this caused the spindle speed settings to work on a wider range ( 0-650) . the previous calibration was at 24,000 and gave me a range ( 0-250) spindle speed.
How do I fine tune my spindle?
thanks again.
Fine tune.
the spindle is still a bit of a problem. I've calibrated with a new pulley to 33,000 this caused the spindle speed settings to work on a wider range ( 0-650) . the previous calibration was at 24,000 and gave me a range ( 0-250) spindle speed.
How do I fine tune my spindle?
thanks again.