1
General Mach Discussion / Re: Rounded corner goes the wrong way
« on: August 23, 2011, 06:51:34 PM »
Many thanks for the quick response!
1. The additional line of N25 G91.1 caused the arc to be drawn correctly. Yes!
2. Setting IJ mode in the general config to incremental resolved the issue with the original file. Perfect!
Great piece of software. Great support. Really appreciate it.
Back to cutting those floor registers...
1. The additional line of N25 G91.1 caused the arc to be drawn correctly. Yes!
2. Setting IJ mode in the general config to incremental resolved the issue with the original file. Perfect!
Great piece of software. Great support. Really appreciate it.
Back to cutting those floor registers...