3
« on: August 20, 2011, 09:52:55 AM »
Thank you Rich for youre very intelligent response,
I'll read it, but after some research, I think that finally, DXF's files made on Solidworks are quite not compatible with lazycam.
Stirling, thank you for you response. I had this problem only when I was using Import dxf's file's option on Mach3, now with lazycam, there is no radius problem, excepted a wrong or unfinished piece.
Can I post one of my dxf files then you try to open it on lazycam ?
Thank's
Ps : there is a DXF attached, after using lazycam, I get this quite wrong g-code :
N5 (File Name = tata on Saturday, August 20, 2011)
N10 (Default Mill Post)
N15 G90.1
N20 G0 Z1.0000
N25 M3
N30 X35.0000 Y-47.0000
N35 Z0.1000
N40 G1 Z0.0000 F60.00
N45 Y-33.0000
N50 G0 Z1.0000
N55 X32.0000 Y-30.0000
N60 Z0.0000
N65 G1 X-32.0000
N70 G0 Z1.0000
N75 X-35.0000 Y-33.0000
N80 Z0.0000
N85 G1 Y-47.0000
N90 G0 Z1.0000
N95 X-32.0000 Y-50.0000
N100 Z0.0000
N105 G1 X32.0000
N110 G3 X35.0000 Y-47.0000 I32.0000 J-47.0000
N115 G0 Z1.0000
N120 Y-33.0000
N125 Z0.1000
N130 G1 Z0.0000
N135 G3 X32.0000 Y-30.0000 I32.0000 J-33.0000
N140 G0 Z1.0000
N145 X-32.0000
N150 Z0.1000
N155 G1 Z0.0000
N160 G3 X-35.0000 Y-33.0000 I-32.0000 J-33.0000
N165 G0 Z1.0000
N170 Y-47.0000
N175 Z0.1000
N180 G1 Z0.0000
N185 G3 X-32.0000 Y-50.0000 I-32.0000 J-47.0000
N190 G0 Z1.0000
N195 X-66.0000
N200 Z0.1000
N205 G1 Z0.0000
N210 G2 I-70.0000 J-50.0000
N215 G0 Z1.0000
N220 X-66.0000 Y50.0000
N225 Z0.1000
N230 G1 Z0.0000
N235 G2 I-70.0000 J50.0000
N240 G0 Z1.0000
N245 X70.0000 Y60.0000
N250 Z0.1000