Hello Guest it is May 23, 2019, 05:54:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cicothemajstor

Pages: 1
1
General Mach Discussion / WATCHDOG DRIVER TRIGGERD
« on: September 27, 2013, 04:47:50 AM »
Hi everybody ,

I have on my MACH 3 error message WATCHDOG DRIVER TRIGGERED . What is this  ?  What I can do after this message ? Do I simmply reset error and start again (for example RUN FROM HERE) ? Can I unchecked this somewhwre in MACH ?
Thank you for help . ???

2
General Mach Discussion / Tool hight measuring after tool change - macro ?
« on: November 03, 2011, 04:21:31 PM »
Hi everybody . Can somebody hellp me with my attendatt to instal an tool hight measuring probe somewhere on my cnc table . I want to after each tool change (for now I change tool manually , mybe in the future via an ATC) press some button or so and then  my router go to the place where my hight sensor is mounted and  measure hight of tool. After measuring , program (macro ?)  im MACH 3 calculate/adjust  the neccesery high  and go ahead/forward with new tool and adjusted tool hight (continious working/routing). Can somebody help me with that please . Mybe something simmillar is allready somewhere on internet ? Thank you in advance for all of yours help . ???  

3
General Mach Discussion / MACH 3 STOPS DURING WORK
« on: August 18, 2011, 06:49:33 AM »
Hi everybody , what is the best procedure to do when  I during work (cuting) on my cnc router recieve message on my MACH scren that "the limit switch is trigerred"  , normaly the machine stops . But the machine not realy triggered limit switch , I think that is because some electric noise occur from time to time . Now my question is how to continues with work . I try simply to resset the warning on the screen and pusch the start button again . But that do not work very god . It is look like a some stepps missing between last stop position and new start ? What I can do ?
Thank for your help . ???   

Pages: 1