Hello Guest it is March 28, 2024, 12:32:32 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ThomasCB21

Pages: 1 2 »
1
Show"N"Tell ( Your Machines) / Re: The Laser Project.
« on: October 16, 2012, 10:11:11 PM »
Ethyl . . . BAD!  Propyl . . . GOOD!

2
Very, very cool!  Hope you make lot's of money!

3
Sieg Machines / Re: Sieg SX4 CNC Conversion
« on: July 01, 2012, 12:46:47 PM »
Holy Cow!  You weren't kidding, this guy has tons of information!  Looks like he's built a complete mini milling center.  I think I may have just found my new best friend. :D  Man, I really appreciate you sending me in this direction.

Chris

4
Sieg Machines / Sieg SX4 CNC Conversion
« on: June 28, 2012, 08:31:55 AM »
Hi All,

  I am looking into purchasing a Sieg SX4 (Grizzly G0720) to do some hobby work, as the kids leave the nest I have a little more time for myself  ;D.  I was wondering if anyone could direct me to anyone who has successfully converted one to CNC?  I was reading the specs on the mill and it has a spindle travel of 3-5/16", I was thinking of using the power lift for the Z motion and leaving the spindle locked in the up position to help stabilize it. 

Any thoughts?  All comments appreciated!

Thanks in advance
Chris

5
Very nice, having read many of your posts, I don't believe there is anything you can't accomplish when there is a need and a desire to build.

6
Nicely done.  8D

Chris

7
Very Cool Steve, I can't wait to this one running.

Chris

8
General Mach Discussion / Re: KFlop and Mach 3
« on: August 20, 2011, 07:46:00 PM »
Will do Ray.

Thanks,
Chris

9
General Mach Discussion / Re: KFlop and Mach 3
« on: August 20, 2011, 02:44:55 PM »
Thanks for the quick answers.  I would like to take this opportunity to thank everyone for the information and the support, I have stepped off into this endeavor with a good mechanical background, but zero in machining department.  I'm sure I will continue to come back here and seek more knowledge and wisedom from you.

Thanks,
Chris

10
General Mach Discussion / KFlop and Mach 3
« on: August 19, 2011, 01:53:24 PM »
S-o-o-o-o-o . . . I was reading on the Dynomotion website, where you needed to know C++ in order to use their board.  Is this true if you Mach 3 with it?  Plus I have begun purchasing bits and pieces to begin my CNC Router.  I will post pictures as the building begins.

Thanks,
Chris

Pages: 1 2 »