Messages

1

General Mach Discussion / mach3 foam cutter heat control.

« on: March 04, 2012, 03:25:27 AM »

I'm korean user mach3. I'm not good at english. I hope you understand my question.
I control heat by dial. very Often i change dial so i cannot choose exact volume.
I hope to control heat by mach3 (use spilndle control)

Do i need any other equipment? (ex. converter ,inverter, ??)

2

LazyCam (Beta) / Re: Lazy cam setup

« on: August 05, 2011, 11:25:32 PM »

hi. i'm korean LC, mach3 user.

i think i have similar problem.

i made lazy cam design. two layer exist. inside and outside.

when i load mach3. mach3 doen't draw indide cut.(for example ABC , A's inside, B's inside)

how can i solve this problem.