1
General Mach Discussion / Re: Mach3 & bobcadcam
« on: July 31, 2011, 01:06:43 PM »
yea, thanks for advice guys...think I will give dolphin a look see
Richard
Richard
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Dont think it will get you banned from here , the BobCAD forum possibly
Well I'm not concerned about being banned from bobcad/cam forum...I'm not a member. I'm not going to pay for bobcad/cam without being able to use it just so I can join their forums.
Lol...that makes me wonder if the reason they wont let you join forum is simply because they want your money or they only want people that will praise their product on their forums? hmmm...possibly both?
Richard
Sabastion,
Calm down - chill.
There are many here willing to help you in any way that they can.
There are also many thousands of extremely satisfied Mach3 users.
Mach3 serves me well but I accept that it may not suit everyone but if you are prepared to put in a little effort learning then I am sure you will not be disappointed.
Tweakie.