Hello Guest it is March 28, 2024, 06:35:01 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Maxmekker

Pages: 1
1
General Mach Discussion / Re: Mach4 doing Feed per rev
« on: December 31, 2013, 05:45:50 AM »
All lathe users miss this, hope it can do tool compensation also. Hope this is released soon or a Beta that can be tested.

2
General Mach Discussion / Re: Mach and Lathe
« on: December 30, 2013, 07:11:48 PM »
I buy a new license on Mach4 if it can do lathe, Mach3 is better than Linux on milling is my experience. And much easier to config, and I hate to write a new PostProseccor to SolidWorks for Linux.
If they need a beta tester for Mach4 I would love to bee a tester.

These parts are made with G95+G96, G42 I had to remove because Mach3 can't handle it  :-\

Here is a video from my lathe, material is 316L, video is speeded up a little.
Video 1

Second video is 6083 aluminum.

Picture is my lathe.

3
General Mach Discussion / Re: Mach and Lathe
« on: December 30, 2013, 06:36:53 PM »
Any ide when it will come?
Starting to consider Linux but have to check out if it works like it should.

4
General Mach Discussion / Mach and Lathe
« on: December 30, 2013, 05:15:21 PM »
Will Mach ever support a lathe fully wit G95+G96 and full tool compensation?
Mach3 is doing a poor job so far in my opinion, on a mill it is doing a good job.

5
*****VIDEOS***** / Video´s from my machines
« on: January 25, 2013, 06:51:17 PM »
Terco 4500 converted to Mach3

DB11V converted

4-axes DIY

Pages: 1