Guest
Show Posts
1
General Mach Discussion / Re: Lost Spindle speed control
« on: July 12, 2011, 01:39:57 PM »
Please post the wiring and settings.
I have been trying for a month to get a 0-10 volt signal out of the Gecko G540 from the Mach 3 software. Gecko Drive's support people are well aware that the majority of their customers use Mach software, but they refuse to see if they can make it work to help support their customers..... Makes sense, right?
-Chris
I have been trying for a month to get a 0-10 volt signal out of the Gecko G540 from the Mach 3 software. Gecko Drive's support people are well aware that the majority of their customers use Mach software, but they refuse to see if they can make it work to help support their customers..... Makes sense, right?
-Chris