Hello Guest it is March 28, 2024, 10:37:29 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JoMachine

Pages: 1
1
General Mach Discussion / oxy-fuel by MACH3
« on: July 11, 2011, 01:37:57 PM »
have any one run oxy-fuel torch with Mach3 ..

i need screen, and how to control the preheat and pierce times .


2
General Mach Discussion / oxy-fuel cutting
« on: July 08, 2011, 06:07:21 PM »
have any one make oxy-fuel cutting by MACH3 .

i was an old user of mach3 , i was worked with plasma .

i need screeen showing the preheat and pierce times .

Regards

Pages: 1