Hello Guest it is March 29, 2024, 09:04:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hoyospetrola

Pages: 1
1
General Mach Discussion / Re: Reverse RUN problem in second pass
« on: July 03, 2011, 02:03:10 PM »
Hi, I´m experiencing the same problem, first time I reverse run it works great but second it goes mad and make the circle outside the original, it never happens in G1 or G0

2
General Mach Discussion / cannot reverse run from present feedhold
« on: July 02, 2011, 05:53:01 PM »
           Hello all, I´m speriencing that trouble all the time when I try to reverse run after loosing cut with my oxyfuel, I have a full licenced Mach3 version but when I stop the program or when i feed hold the program it shows all the time that alarm "cannot reverse run from present feedhold", then it doesn´t allow me to move the program backwards and then the program execution goes to the begining of the program :( . I found a topic with that subject but they don´t explain anything about that, they talk about a pins config etc. I tryed run reverse few times at the begining and it worked, but for some reason now doesn´t, maybe I have to change something in my postprocesor?

Thanks everybody beforehand.

3
Mach Screens / Re: OEM Triggers and soft buttons without OEM codes
« on: June 22, 2011, 05:04:02 PM »
Hi have a similiar question, I´m trying to setup six keys in my keyboard (F1,F2,F3,F4,F5,F6) to connect preheat, disconnect preheat, activate plasma cut, deactivate plasma cut and activate O2 cut and deactivate O2 cut I got runing for a while that famous M301 subrutine by mean of a OEM key linked to a hotkey. For some reason wich I don´t know some times that procedure doesn´t work. Is anything else that I should do to get that runing like execute some especial command or so?. Would that work if I write inside de M301 script sentences like if IsActive (OEMTRIG1) Then ActivateSignal(Output1)
                                                                                                                                    if IsActive (OEMTRIG2) Then ActivateSignal(Output2)
                                                                                                                                        Etc, etc etc....
Nice to kee in touch with all you and thanks beforehand.

4
Thanks a million for your quick replay, Can you please tell me where can I find the THC acceleration rates controls?

5
At last!!!!!!!!!!!, I found out why my torch doesn´t work properly!!!!!. I have noticed that trouble, after moving the Z axis with thc up or down buttons Z axis looses many steps, and works so noisy but with your jog buttons it runs very fast and smooth, I´m also using the commands JogOn for moving my Z axis within one script and once you push these buttons it runs nuts. How should I set up my stepper amplifier to react without acceleration?

Thanks everybody for such a useful forum.

Pages: 1