Messages

1

G-Code, CAD, and CAM discussions / Re: Zero point of Y Axis resets

« on: March 09, 2008, 11:47:01 PM »

Hi,
i could try this tomorrow.

It seems that the complete milling after the error gets shifted about 1cm toward -Y.

The job display doesn't show this either, only the pcb gets trashed.
Hmm I think i will try another G-Code converter just to be sure. At second thougt, i think it could be the point where the second pass starts.

Thank You
Adrian

Hi Adrian,
  Please let me know what you find out about this.
After the shift happens, if you move to the (0, 0, 0) point, is it off 1cm also? If so, you could be losing steps in Y.

Regards,
  JJ

2

Competitions / Re: ******Guess and win a G100 Grex******

« on: May 22, 2007, 09:19:07 AM »

2_157_362
Regards,
  JJ

3

General Mach Discussion / Re: Should we start a few new catagories ?

« on: February 02, 2006, 07:38:25 PM »

How about adding some sort of keyword capability? That way, if you don't know what to call what you're looking for, you can just start at message x and work your way back. If you know it is related to x, then you can search for that. I believe this would solve the problem of messages that don't fit in one particular category as well. For instance, "What is the best way to use the charge pump?" Clearly, this is a hardware / electrical / software / interface / motor driver question. With keywords, it could be all 5 at once. To prevent typos, a multiple choice list could be created.

Regards,
  JJ