1
General Mach Discussion / Re: how to setup the steps per unit in config->motor tuning
« on: December 17, 2012, 08:54:46 PM »
Hey Guys,
I got the same set up with Lucky 021. I got everything set up and be using over 1 and half. But my Feed rate is to fast. I keep breaking bits and reducing my original speed of feed cut down by 80%.
My question is how can I get my motor tunning slower. i'm using 45K on the freq. and step per 40,000..... 67.5 in per min. ........ 5.5 Acelleration per in.
Where am I going wrong Here?
Tim
I got the same set up with Lucky 021. I got everything set up and be using over 1 and half. But my Feed rate is to fast. I keep breaking bits and reducing my original speed of feed cut down by 80%.
My question is how can I get my motor tunning slower. i'm using 45K on the freq. and step per 40,000..... 67.5 in per min. ........ 5.5 Acelleration per in.
Where am I going wrong Here?
Tim