Hello Guest it is August 06, 2020, 09:41:27 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - MasterAnubis

Pages: 1
1
General Mach Discussion / Re: 8877 and 9991 error on startup.
« on: June 24, 2011, 12:59:17 PM »
Thanks for the reply.  I remember (now) seeing another issue somewhere that had that as a part of the troubleshooting. 

I ened up going another route.  I used a smaller hard drive and started a fresh install of XP.  This is now my dedicated machine so this was a good route anyway(I could reclaim the larger hard drive).  During the process I found out that I had a bad CD drive and it was making me have some very bad errors with my bios.  I don't know if it was draging down data lines or just not cooperating.  After getting a good DVD drive installed I went back to the old drive to see if that was the issue.  No, it wasn't.  So I continued with the install on the new hard drive.  Everything is running well now so if it was a hardware issue it would have been that CD drive. 

I'm happy that it's working well and it seams that I have an ideal setup.  Unfortunately, I'll never put the old drive back in it so I'll never know if the drivers where the real issue.

Thanks again,
Shawn ;D

2
General Mach Discussion / 8877 and 9991 error on startup.
« on: June 22, 2011, 11:29:53 AM »
I was hoping not to need to post such a question, but I don’t know where to turn without starting from scratch. 

Problem:
I have an 8877 error when starting Mach3 (newest lockdown)  and then a 9991 when clicking yes.  It shuts down when clicking no.

Background:
I’m a noob to CNC and I had things running smoothly for a couple of weeks.  Then I changed the computer’s case and video card to better fit in my shop.  I’ve not found any hardware conflicts or other errors on the computer.  I’ve uninstalled and reinstalled Mach3 and uninstalled then deleted the remaining files in the folder then reinstalled.  I’ve read about plugin problems so I have even tried removing them to no avail.   The plugin issues I’ve heard about where related to Smooth Stepper and not the Taig setup. 

I’m completely OK with it being a hardware issue(my fault) and not software but I was hoping someone might have a suggestion that I haven’t tried.
 ???
Thank you,
Shawn

3
Hi all,
  I'm Shawn and I have a background in Calibration as well as a bit of home brew experiences that give me broad base in 'mild' fabrication.  I'm a classic Ford guy and have just recently broken into the realm of CNC with my Taig Micro Mill.   This month I've updated my controller and got with the Mach3 program. 

  I've had some great results with Vcarve doing just what I need it to do.  Mach3 really woke up my Taig.   ;D

Pages: 1