Hello Guest it is July 22, 2019, 05:15:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - farmer53

Pages: 1
1
I am using Masc3 on a plasma table. I use sheetcam. My feed rate is 135 ipm but the unites per minute has been as high as 260.

I have no idea what, when or how I changed something to cause this problem.

I have tried changing the kernel speed, step and direction pulse and looked to see if I could find anything that looked related to speed.

In motor tuning I have velocity set at 200 and acceleration at 20 and fro at 100 percent.

If I change fro to about 60 percent or change velocity to around 60 then it will run up to about 135 ipm in the DRO for units per minute.

Any suggestions would be appreciated. I am about to reinstall mach3.

Thanks
farmer53


Pages: 1