Messages

1

General Mach Discussion / Re: home slaved axis

« on: June 04, 2011, 07:42:11 AM »

Thank you,

I hope it will work.

Best regards
Raivo

2

General Mach Discussion / home slaved axis

« on: June 04, 2011, 06:49:17 AM »

Hello,

I use mach3 for my 3-axis plasma cutter. 4th axis A is slaved with Y-axis. I use home limit switches and spindle A also has one. If I check the "home slaved axis with master axis" under general configuration then it homes like this: first Z then Y and then X. It does not use A switch. If I un check it then it homes like this: first Z then Y and A then X and then A again. Is there a way to configure it so that it homes A only once with Y using both switches?