Messages

1

General Mach Discussion / Re: help mach3

« on: May 31, 2011, 08:56:30 AM »

Thanks anyway. I'll try to find the right combo. But, thanks for all your help.

2

General Mach Discussion / Re: help mach3

« on: May 30, 2011, 11:53:15 PM »

Thanks for your help. Would you happen to know the best velocity to set it at.

3

General Mach Discussion / Re: help mach3

« on: May 30, 2011, 03:37:41 PM »

thank's alot your help was great. I finally got my motors running right, But, wondering if you could help me with the motor tuning. I am using 1/2-13 lead screws and I don't know how to figure the steps per inch.

4

General Mach Discussion / Re: help mach3

« on: May 29, 2011, 12:04:18 AM »

  I finally got my motors to turn, but now when I jog x the motor only turns in the positive direction. Can anyone help me out. I checked the number 4 pin on my parallel port and it stays at 4.2 volts when I press my left and right arrow keys. Thank You

5

General Mach Discussion / Re: help mach3

« on: May 28, 2011, 09:39:30 AM »

Thank you. I'll check to see if anything is active.

6

General Mach Discussion / Re: help mach3

« on: May 27, 2011, 11:57:40 PM »

  I need help. When I take the voltage readings on the parallel port I get 3.2 volts but, as soon as I start Mach3 all my voltages fall to zero. Can anyone help.
Thank You rbailey41