Hello Guest it is March 29, 2024, 02:32:13 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - macatoms

Pages: 1 2 »
1
General Mach Discussion / Re: Aspire 4.0 post processor for ROMAXX HS1
« on: February 11, 2014, 11:20:34 PM »
typing mistake  I mean  +and- 

2
General Mach Discussion / Re: Aspire 4.0 post processor for ROMAXX HS1
« on: February 11, 2014, 11:18:38 PM »
Iam using mach3 inch arc post and its adding t/c and my z axis is trying to drive past limits = and ?

3
General Mach Discussion / Aspire 4.0 post processor for ROMAXX HS1
« on: February 11, 2014, 10:13:10 PM »
Is there anyone that has made a post processor for Vectaric Aspire for a ROMAXX HS1?
I spoke to Ron at romaxx and he said the Vectaric was going to write  one but thats been
long time ago.I would do it myself but I am not that smart!Any help would be appreciated.
              Thanks Dave Mcadams

4
Thanks so much, worked like a champ!!!!!Dave Mcadams

5
Can anyone tell me what I need to alter to be able to cut a logo in reverse on lexan so it reads correct on the smooth side.Thanks Dave.

6
Share Your GCode / Re: I NEED THE KISS LOGO IN G CODE
« on: May 10, 2012, 12:11:30 PM »
Thanks for making that code for me.Dave

7
Share Your GCode / Re: I NEED THE KISS LOGO IN G CODE
« on: May 10, 2012, 08:57:32 AM »
I was wondering if you could make 2 more logos for me?I need  the Megadeth logo and Iron maiden logo.If its to much trouble I understand!I thank you for your help and response.Also do you know much about lazy cam?Iam trying to use it but it seems to be kind of less than equal to the Mach3 standards.Thanks Dave

8
Share Your GCode / Re: I NEED THE KISS LOGO IN G CODE
« on: May 09, 2012, 02:15:18 PM »
Thanks man.I see you used v carve to make this file.Do you like it?Do you know if someone sells some older versions of v carve.The moneys the issue.Iam a vet on disability and cant spring for the good software.Thanks again Dave Mcadams.

9
Share Your GCode / I NEED THE KISS LOGO IN G CODE
« on: May 08, 2012, 08:15:38 PM »
IF ANYONE HAS THE KISS LOGO IN G CODE THAT WOULD BE GREAT.THANKS

10
General Mach Discussion / Re: part size in tool path
« on: May 01, 2012, 04:22:13 AM »
Thanks a lot for your help!

Pages: 1 2 »