Hello Guest it is March 28, 2024, 02:08:43 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - stab

Pages: 1
1
Hi again,

Thanks for replying.
Tried your suggestion with "Config menu then set native units" but I get a warning-message:
Do NOT use this to change between Metric and English GCode. This is for setting ther units for motor tuning.

I'm using Mach3 Version R3.043.022 and in the config drop-down I don't find any entry indicating a way to
set millimeters as default.


2
What entry would that be and is it just a recalculation according to the ratio 25.4(mm) / 1(inch)?

stab

3
Hi,

Could someone instruct me on what entry to set in the config file, for Mach3 to start up with
millimeter setting instead of inch

Regads
stab :)

Pages: 1