4
« on: August 10, 2011, 03:41:48 AM »
Hi Gerry
First off, Very nice job now that I've spent the last day and a bit familiarising myself with your screenset.
I'm having a few issues though! it could be hardware related possibly and not those dreaded bugs.
All was going perfectly, plunge after plunge until it started to have trouble sensing on the second slow plunge and fortunately pushed the cutter up into the collet.
Ofcorse it doesn't do this every time though.
I'm using the current non lockdown Mach3 and the 4 axis X Diag. 2010 set. has there been anything reported like this before?
All my connections seem fine.
On another note, I have 650mm of travel on my Z, How do I remove the Limit on the max sense length?
Thanks
Liam.