Hello Guest it is April 17, 2021, 01:57:06 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - edcross

Pages: 1 2 »
1
Mach4 General Discussion / Re: M6 Script Problem
« on: January 02, 2021, 01:20:40 PM »
Brian , i was able to create a button called tool change in the jogging panel . How do i add your M6 script it it , i did not see that in the example video .

     Thanks   Edcross

2
Mach4 General Discussion / Re: M6 Script Problem
« on: January 02, 2021, 08:37:22 AM »
Brian , is there a video on how to insert a button on the mach4 screen ?

3
Mach4 General Discussion / Re: M6 Script Problem
« on: December 31, 2020, 04:37:44 PM »
Mach4 v 4300 , vcarve desktop pro v 10.5  , PP attached , script from newfangled video on youtube.com - using Mach2/3 atc inch pp from vcarve attached . Can you help edcross

4
Mach4 General Discussion / New Mach4 hobby simulator
« on: May 08, 2020, 02:01:23 PM »
Anyone using the new beta mach4 simulator , have a question on how to setup cnc table to match cutting file .

     Thanks

       Ed

5
Mach4 General Discussion / Re: Vcarve
« on: May 01, 2020, 09:32:39 AM »
It will not reset until you close mach 4 and unplug/plugin smartbob

   Ed

6
Mach4 General Discussion / Vcarve
« on: April 30, 2020, 04:27:23 PM »
Anyone have trouble with vcarve desktop v10 and mach 4 v 4300 with PMDX 411 smartbob , ERROR = cannot communicate with device.

    Ed

7
Mach4 Plugins / Re: Stupid Vista Plug in, S and V reversed
« on: April 02, 2020, 11:14:56 AM »
I have a p 4-s and when i jog from it any axis it will trip mach 4 v 4300 error code motion underrun 7, reset and it may work a couple times , then faults again . Wrote to zista but no reply yet .

8
I want to turn on output #5 on gecko g540 control through Mach4 . Which pin should i use in the pmcx 411 , do i need to set up spindle parms ??

     Ed

9
Mach4 General Discussion / Mach4 axis
« on: May 19, 2017, 03:35:22 PM »
How can I change Z to X in Mach 4  Lathe

10
Mach4 General Discussion / axis change
« on: May 19, 2017, 11:39:27 AM »
I need to change my Z axis to X axis in Mach 4 Turn, because of my cad program Bobcad v 29 Turn.

Pages: 1 2 »