Hello Guest it is September 25, 2023, 01:56:37 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - jasonixo

Pages: 1
New to all of this, but I have a Microkinetics Sherline Mill that jogs and runs basic MDI commands fine.

-Set to 8000 steps (1.8steps, half-step drives, 20tpi screws)
-Native Units set to inches
-Machine moves the commanded distance in any direction and DRO reflects this

If I try to engrave my name in the Write Wizard and write the GCode, the machine scaling goes nuts.  My Y DRO goes to -50.something, and any 1" movement in MDI moves the machine about .100.  My motor tuning values remain correct.  G20 appears in the program as well.  To clarify, this happens when I write the program, before I attempt to run it.  Does this sound like a problem with a common solution?

Thank you-


Pages: 1