Hello Guest it is May 06, 2021, 03:28:53 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - iameer

Pages: 1
1
General Mach Discussion / Re: Scaling problem
« on: January 31, 2006, 12:22:58 PM »
Many thanks Art
had a look in Deskart, and looked at the settings.
you were right, the default output makes everything
smaller (never thought to check that!)
sorted!

2
General Mach Discussion / Re: Scaling problem
« on: January 31, 2006, 11:53:43 AM »
Hi thanks for the reply
I convert the pic to code using Deskart then import to mach2.
the pics are normally wmf or bmp format.

3
General Mach Discussion / Scaling problem
« on: January 31, 2006, 11:38:31 AM »
# Newbie #  Could anyone tell me why when I have converted a simple drawing
of about 6" x 8" to gcode, and then imported to mach2, the toolpath is a lot
smaller even if I change from  mills to inches. Is the scale lost in conversion to
gcode or can I alter something in mach2.? Any help much appreciated.

Pages: 1