1
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: May 10, 2016, 05:12:55 PM »Kvom do you have any pin states set in M4
Not sure what that means.
I have seen two things that make me suspicious that Darwin and M4 may have some issues playing nice together.
One issue is that on startup, the charge pump led doesn't illuminate. I have to cycle the disable/enable button to turn it on. I see the leds come on briefly at startup, but then go off as the lua screens load.
Second issue is that none of the indicators in the M4 diagnostic screen change state.