Hello Guest it is March 28, 2024, 06:14:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - baccus61

Pages: 1
1
General Mach Discussion / Re: New PlugIn just about done..
« on: February 04, 2012, 02:46:36 AM »
Hi Guys.
I have skimmed through the posts for the Shuttle Pro V2 and I can't find a reference to my problem.
I have tried nearly all the functions form the Shuttle which seem to work pretty good and I am happy about the way it works etc but I can't get my limits to work.
I have them enabled and they all worked fine until I uploaded the Pro plugin.  I press the limits and the LED shows it working in the diagnostic screen but when I do a "Home all Axis" they don't work.  They also don't work when I do a single axis at a time.
Any ideas?

Also  Quote " It is furstrating in a way. Myself and others here, release stuff (often for free), to help out the community at large, but you cannot tell if they like the stuff, or what. You see the downloads but dont see any comments...."
Unquote.
I have notice here and other forums ie cnczone etc. that when you need feedback there isn't any unless there is a problem.  It's a case of no news is good news.
Also, it took me about 6 weeks before I set up my shuttle Pro after I downloaded the plugin due to trying to find a cheap one because of not knowing if it will work or not with my set up.  I know what it's like waiting for weeks for something and nothing turns up.!
Now is my chance.......
I REALLY appreciate you guys doing all this stuff because I am not capable of doing it myself and I try to give back as much as possible IF I know the answer to something and not to just voice an opinion.  You guys do great work so THANK YOU VERY MUCH. 
There, I said it. :-)
(and I mean it)
Richard.

2
Competitions / Re: ******Guess and win a G100 Grex******
« on: May 16, 2007, 10:08:25 AM »
My Grandmother says it looks like the dandruff from her old man and reckons it was 2.3 Kilograms worth.  or about 2,421,567 pieces.
So that's my guess.  2,421,567
PS.  what was the chip load,spindle speed, feed rate and time of the cut?
Rich
 

Pages: 1