Hello Guest it is March 28, 2024, 09:06:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Rideredcr

Pages: 1 2 »
1
General Mach Discussion / Re: Motors will not spin
« on: March 29, 2011, 08:33:14 PM »
I wanna thank you guys for all your help. Everything works fine now. I installed the .xml, I reinstalled Mach, rebooted the computer and now I'm up and running. Thanks again

2
General Mach Discussion / Re: Motors will not spin
« on: March 29, 2011, 10:49:55 AM »
It doesn't matter if I hit the reset button or not....the motors always hold now. I noticed when I start Up Mach I get an error message that says: ERROR STARTING AFTER PREP. I click ok, then Mach starts up, but under the status bar it reads: ERROR STARTING ENGINE. Ill play around with the address and see if I get any where

3
General Mach Discussion / Re: Motors will not spin
« on: March 28, 2011, 11:15:52 PM »
This is the .xml file for Taig mill

4
General Mach Discussion / Re: Motors will not spin
« on: March 28, 2011, 11:10:03 PM »
Ok I made some forward progress today. I received installation instruction from the guy I bought the mill from. I installed the .xml file that came with the instructions and now the motors hold(they have power), but I still can not get them to jog. I checked my pins again for voltage. All Dir pins have 3.5v and all Step pins have 3.5v. There is no change in voltage on any pin when I jog. Any ideas?

5
General Mach Discussion / Re: Step motors problem - no movement
« on: March 28, 2011, 10:12:40 PM »
Thanks

6
General Mach Discussion / Re: Step motors problem - no movement
« on: March 28, 2011, 11:51:08 AM »
Marcin81 what port card did you install.? I believe I have the same issue.

7
General Mach Discussion / Re: Motors will not spin
« on: March 28, 2011, 11:24:13 AM »
It is a Microproto controller. According to the wiring diagram I got with the controller, it has gecko g201 drivers

8
General Mach Discussion / Re: Motors will not spin
« on: March 27, 2011, 07:07:59 PM »
Ok Im going to try that........but I just tested it again....... and now I'm getting -99mv in the - direction and -250mv in the + direction..........I hope a new board work. Thanks for the help.

9
General Mach Discussion / Re: Motors will not spin
« on: March 27, 2011, 05:57:41 PM »
I haven't changed anything, but now I'm getting 104.5mv when I  jog in the + direction. The voltage stays at 104.5 until I jog in the - direction, in which case the voltage goes to 3.5v and holds there until I move in the + direction. Is this normal? By the way thanks for all your help!

10
General Mach Discussion / Re: Motors will not spin
« on: March 27, 2011, 05:33:48 PM »
ok tell me if you can open it

Pages: 1 2 »