Hello Guest it is April 10, 2021, 09:20:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mariah

Pages: 1 2 »
1
General Mach Discussion / Re: Help needed to engrave emblem...
« on: April 08, 2021, 12:50:28 AM »
Big thank you to everyone who helped me through this project.  I finally got-er-done!!!!!!!!!!!!!!!!

2
General Mach Discussion / Re: Help needed to engrave emblem...
« on: April 07, 2021, 04:41:28 PM »
Anybody around Butler Co., PA who will come to my house and help me get this straightened out?  Will pay to have this put in working order!

3
General Mach Discussion / Re: Help needed to engrave emblem...
« on: April 07, 2021, 12:10:24 PM »
These computer terms are all beyond me, please explain in simple beginners terms.

4
General Mach Discussion / Re: Help needed to engrave emblem...
« on: April 06, 2021, 10:32:31 PM »
Well I got F-engrave loaded to my PC but it's not working quite properly.  Would somebody help me with unzipping files etc. so it will pork properly?  There are no type fonts and it won't generate G-code.    Thanks

5
General Mach Discussion / Re: Help needed to engrave emblem...
« on: April 01, 2021, 06:46:10 PM »
When I figure out if I can do this job on my mill I should be able to get a crisp image from the person who made the drawing.  Sorry for not mentioning that sooner.

6
General Mach Discussion / Re: Help needed to engrave emblem...
« on: March 31, 2021, 10:51:51 PM »
********* 

7
General Mach Discussion / Re: Help needed to engrave emblem...
« on: March 31, 2021, 10:21:50 PM »
*********[

8
General Mach Discussion / Re: Help needed to engrave emblem...
« on: March 31, 2021, 06:55:35 PM »
Try again      Give up cant even send a picture, machine will set another 10 years for mdi things

9
General Mach Discussion / Re: Help needed to engrave emblem...
« on: March 31, 2021, 06:07:15 PM »
Here it is, just the center item not the text above or below it.

10
General Mach Discussion / Re: Help needed to engrave emblem...
« on: March 31, 2021, 02:01:10 PM »
Thanks Tweakie, seems very complicated for my level.  Is there a simpler way for a novice?

Mariah

Pages: 1 2 »