Guest
Show Posts
1
General Mach Discussion / FEEDRATE 10% INCREASE/DECREASE CHANGE VALUE
« on: June 12, 2013, 04:34:27 PM »
Does somebody know a SIMPLE WAY to change the 10% feedrate step to a lower value (e.g. 3%) in MACH3.
I use MACH3 plasma setup, and in MDI screen, F10 and F11 may be used to increase or decrease feedrate by 10% step. But this step is too big, as we use oxy-propane torch, and feedret must be adjusted very precisely in 2% to 3% increment only.
I suppose this paremeter may be modified somewhere in a configuration file, but i don't find anything about it.
Any help welcome.
I use MACH3 plasma setup, and in MDI screen, F10 and F11 may be used to increase or decrease feedrate by 10% step. But this step is too big, as we use oxy-propane torch, and feedret must be adjusted very precisely in 2% to 3% increment only.
I suppose this paremeter may be modified somewhere in a configuration file, but i don't find anything about it.
Any help welcome.