Hello Guest it is March 28, 2024, 09:39:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - slow

Pages: 1
1
Tutorials / Re: G-Rex setup guide for new users
« on: June 23, 2006, 12:51:55 AM »
I must be missing something simple.  My new G100 powers up and looks fine with the DIR lights and the yellow RUN light on.  The Grex loader finds my G100 fine.  "Launch Firmware Loader" gives me an Explorer window with a "cannot find server" error.

My G100 may already have the Mach4 firmware.  Jan at Gecko asked me which firmware I wanted.

I started Mach4 with the G100 address and get "G100 config not found".   On the GREX page "Next Seq" increments when I try to jog, but "Curr Seq" stays zero.

Please let me know what I have overlooked.

Thank you,

David

2
General Mach Discussion / softlimits
« on: January 28, 2006, 09:32:30 PM »
I am having a problem using softlimits.

My configuration units are metric.  The X limit is 600 mm.  Softlimits seems to work fine.

If I change units to inches on the setup page softlimits stops the X axis at .93
instead of 23.6 inches.  Softlimits has shrunken my X axis by a factor of 25.4

--slow

Pages: 1