Hello Guest it is July 20, 2019, 11:19:02 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Hal

Pages: 1 2 3 4 5 6
1
Try an angle of 1.4312 degrees.
.6/12=.05
inverse tan of .05=2.8624 degrees of cone
2.8624/2=1.4312 degrees per side for a Jarno Taper #2

2
General Mach Discussion / Re: 3040Z issues again.....
« on: May 06, 2013, 11:12:18 PM »
You can keep the motors and cables.

I would update the motors and cables. A little easier if you can wire.

3
General Mach Discussion / Re: 3040Z issues again.....
« on: May 06, 2013, 09:26:38 PM »
GECKO 540

I own two. When my 3020 box dies I will own a third.

You will need a power supply and spindle drive board.

4
General Mach Discussion / Re: G-code Question
« on: January 21, 2013, 08:25:23 PM »
There maybe a delay in the coolant coming on in the machine itself.
Hal

5
I am glad you got your issue fixed.

G64 can be used for 3d work and roughing if there is enough stock being left.

Check your CAM system, you should be able to add it to your first safty block. If you are using the wizards type G61 in MDI before you start.
Somewhere in the Mach3 system setup may be a line to set G61 as default.

Hal

6
Put G61 in the start of your program. Check for G64 and delete

Hal

7
Try turning on G61 and slow your feed rate a little.

Hal

8
General Mach Discussion / Re: unwanted creep in jog mode?
« on: January 16, 2013, 11:52:47 AM »
I wonder if the Chinese pendant is sticking or randomly resending the command? Is the creap the same as the last botton on the pendant? Can you try a ps/2 keyboard?

Hal

9
Look at your steps/unit setting under motor tuning. Try doubling this number. If the DRO moves one inch does the machine move one inch? You can also try the calubration part of Mach3.

Hal

10
General Mach Discussion / Re: What would cause my limit switches to trip?
« on: December 25, 2012, 06:29:39 PM »
Is the cabinet grounded?

Pages: 1 2 3 4 5 6