Hello Guest it is September 15, 2019, 05:15:33 AM

### Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

### Messages - ghostlx

Pages: 1
1
##### General Mach Discussion / Re: would like some advice
« on: March 07, 2011, 10:55:57 PM »
rich
changed my motor tuning to 100imp and 8 in acceleration
wow does my machine sound smother
ghostlx

2
##### General Mach Discussion / Re: would like some advice
« on: March 05, 2011, 02:04:03 PM »
Note the following:
The max velocity in motor tunning is limited by the available pulses / Kernel Speed:
KERNEL SPEED / STEPS PER UNIT X 60= MAX IPM
IE; 25000/20000 x 60= 75 IPM max so if you want more velocity you will need to increase your Kernel Speed given the axis steps per unit shown

thank you very much
i'll set my ipm to75 and my velosity to 8 and see what happens
thanks
ghostlx

RICH

3
##### General Mach Discussion / Re: would like some advice
« on: March 05, 2011, 08:16:02 AM »
thanks tweakie
i found a earlier post on the subject that ritch posted.
i'll start their
ghostlx

i found this from ritch

View Profile Personal Message (Offline)

Re: motor tuning
« Reply #2 on: February 24, 2011, 06:36:33 AM »
Quote
how to tune the motor

- Pick a start velocity , leys say 10 ipm and an accel of 1 , jog the machine, will assume it didn't skip
- Now double the velocity and accel....20 vel / accel 2,             "                           "
- keep doubling the velocity an accel until it skips ie,  40/4, 80/8, 160/16 willl assume it skips
- now lower to say 120 / 12, assume it ships
- now use 100 / 10 and assume it doesn't skip
- so  now increase by 10 to 110 / 11........lets say it skips
- so lower by 30% or more , say 75 / 8 , i like to be conservative and leave enough "headroom" for machining tasks so that the axis will
not skip for the maching tasks that i will do.
- At this point you play some with the accel by jogging in smaller moves

Doing the above, you have found the max velocity and acceleration when doing a rapid where the machine will not skip. By reducing the values
you are trying to make sure that your machine will be reliable when  machining. You should test  the final setting some by jogging in small and long moves and by actualy cutting different materials.

How fast you can accelerate and decelerate depends on how your axis system will react to the load it is trying to move or stop. A velocity of 0 to max  & from max velocity to  a stop in a some distance.

Hope this helps,
RICH

4
##### General Mach Discussion / would like some advice
« on: March 04, 2011, 09:51:53 PM »
i have built a cnc router with 4 nema 23 motors, a g540 and a 48v power supply . it is rack and pinion on x and a 5 start 1/2" acme lead screw for y and z axis i would like to have a smooth running machine as be well balance in speed and tork would you pleas look at these screen shots and advise on what is best
thanks
ghostlx

Pages: 1