Hello Guest it is December 13, 2019, 03:49:25 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - GMezzacapo

Pages: 1
1
Spanish / Re: Micro goteo
« on: May 05, 2011, 10:49:16 AM »
Muchas Gracias gzm.pepe, lo voy a probar, tambien me comentaron que se podia hacer por la via del Brain Control, en la cual no estoy para nada familiarizado. Saludos


Gianni

2
VB and the development of wizards / Re: Micro drip system
« on: May 05, 2011, 10:44:40 AM »
Ian, works great Thank you very much. You help me to discover a new part of the software.

Gianni

3
Spanish / Micro goteo
« on: May 04, 2011, 05:19:58 PM »
Hola Estimado Amigos, estoy tratando de hacer un sistema de goteo para mi CNC, por lo que quisiera aplicar una bomba peristaltica que me permite suministrar aceite por gotas, sin embargo mi problema es que no puede funcionar todo el tiempo y este deberia tener un intervalo de encendido de unos 5 segundos y apagado unos 10 seg y repetir el intervalo, y claro que funcione con el motor de corte, el caso es que esta ultima opciones es mucho mas sensilla pero no se si hay alguna forma de que el Mach3 pueda encender y apagar un pin del puerto paralelo por los intervalos que mencioné.

Gracias de antemano por las ideas


Gianni

4
VB and the development of wizards / Micro drip system
« on: May 04, 2011, 01:43:13 PM »
Hi There, I have 2 questions

I am trying to find some way to use a peristaltic pump to add oil drops to my engrave, so I found a pump to do that but It can not run continuously, is there any way to the mach3 turn on 5 sec and off for 20sec a parallel port pin when the spindle is on?

When the gcode finish is there any way to the z axis will be more high than a 1mm? I always has to change manually the z en the gcode

Thanks

Gianni

5
LazyCam (Beta) / Re: 49 lines Limit
« on: February 21, 2011, 09:53:23 AM »
Yes Rich Thanks, that was the solution. Regards


Gianni

6
LazyCam (Beta) / Re: 49 lines Limit
« on: February 20, 2011, 07:16:32 PM »
Thanks, it was the problem the license come with serial in the file name, removing it and the problem was solved. Thank you very much


Gianni

7
LazyCam (Beta) / Re: 49 lines Limit
« on: February 20, 2011, 09:15:13 AM »
Hi Rich, I have a Mach3 license, I am only doing a letter from a dwg file, when I try to export to mach3 it only give me 49 lines.

8
LazyCam (Beta) / 49 lines Limit
« on: February 19, 2011, 11:37:22 PM »
Hi Everyone, I had received my Mach3 license from zentoolworks, but the lazycam only process 49 lines to mach3, the license was saved in mach3 folder, and I can process more than 500 lines in mach3 but the lazycam not. Sorry if the topic was solved before, I can't find it in the forum. Thanks for the help.


Gianni

Pages: 1