Hello Guest it is May 12, 2021, 02:45:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - p1lts

Pages: 1
General Mach Discussion / PC Requirements
« on: February 01, 2011, 05:01:14 AM »
Hi all

Totally "green" newbie here. Inote that the PC requirements to run Mach 3 a re quite basic. I'll be loking to purchase an "old" box specifically to run my mill. jst one question. The website specifically requirs an off-board graphics card. Is this absolutley necessary?


Pages: 1