1
Feature Requests / Mach3 Softlimit by dxf
« on: December 14, 2017, 05:48:44 PM »
So to use mach3 for metal spinning machine and ease of programming.
In teach in mode with joystick command, programming of part can be done,
but the problem is in crashing in the part by overreacting with joystick commands.
So to overcome this problem I tought if someone can make some sort of plugin/wizard
that load .dxf or some 2D drawing that represents softlimit to mach3 (X,Y), but not cousing reset state,
simply not allowing manual joystick control or any other to go pass by these softlimits.
If someone can do it, I would like to know.
Thanks!
In teach in mode with joystick command, programming of part can be done,
but the problem is in crashing in the part by overreacting with joystick commands.
So to overcome this problem I tought if someone can make some sort of plugin/wizard
that load .dxf or some 2D drawing that represents softlimit to mach3 (X,Y), but not cousing reset state,
simply not allowing manual joystick control or any other to go pass by these softlimits.
If someone can do it, I would like to know.
Thanks!