1
General Mach Discussion / Re: Auto Zero Is Not Working - Please help.
« on: July 29, 2010, 11:11:10 PM »
Nils, Would have emailed but cant right now.
Anyways you have all your inputs and homing going to pin 15 it looks like. Manual states that you will need to home each axis independently and not use RefallHome.
Cut, Copy Paste out of the manual.
4.5.5.4 Home Switches of Multiple Axes Connected Together
If you are really short of inputs to Mach3, then you can OR the Home switches together and define all
Home inputs to be that signal. In this case you can reference only a single axis at a time -– so you
should remove REF All buttons from your screens – and your Home switches must all be at the end of
travel on their respective axes.
I ended up wiring Jimmys independantly, I just have to figure out how to stop the autosquaring for him.
Anyways you have all your inputs and homing going to pin 15 it looks like. Manual states that you will need to home each axis independently and not use RefallHome.
Cut, Copy Paste out of the manual.
4.5.5.4 Home Switches of Multiple Axes Connected Together
If you are really short of inputs to Mach3, then you can OR the Home switches together and define all
Home inputs to be that signal. In this case you can reference only a single axis at a time -– so you
should remove REF All buttons from your screens – and your Home switches must all be at the end of
travel on their respective axes.
I ended up wiring Jimmys independantly, I just have to figure out how to stop the autosquaring for him.