Hello Guest it is March 28, 2024, 09:23:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tiggabean

Pages: 1
1
General Mach Discussion / Re: Calibrating spindle reversed?
« on: December 14, 2018, 09:28:13 AM »
I'm using a Veichi AC70

I managed to solve it.
Now I'm missing RPM's in Mach, but speeds are correct when using the S command.

 

2
General Mach Discussion / Calibrating spindle reversed?
« on: December 14, 2018, 12:55:17 AM »
Hi There

I tried to calibrate my spindle last night.

But the calibration was reversed.   speed 24000  actual spindle 0 RPM
how do I adjust this.

Thanks for your input


3
FAQs / Re: Driver Question mark
« on: December 10, 2018, 02:04:11 AM »
Thank you for the reference,
 but will this assist with the driver?

4
FAQs / Driver Question mark
« on: December 07, 2018, 12:22:26 AM »
Hi All

I'm a newbie, trying to setup a cnc.

I have a Hp with Win7 32bit with a pci parallel port.

Every time I try to install Mach 3 I get a blue question mark displayed on the driver.
Driver test gives excellent results, but I cannot get anything moving on the cnc.

Any bright ideas to fix this?

Pages: 1