Messages

1

General Mach Discussion / Re: "run from here"

« on: January 22, 2011, 03:04:45 PM »

ok........pretty scary stuff for a Newbie.
I am retired now........used to have a young "whipper snapper" doing all these details for me
Its a lonely world now............have to look at the end of my own arm for a hand.
Thanks to all who answered my SOS

Pete in Lower/Slower Delaware

2

General Mach Discussion / Re: "run from here"

« on: January 22, 2011, 12:22:54 PM »

ok.........
Some of the "pros" now tell me to NOT run from the USB stick.
Random ********* will happen............so they say.
All good advise................thanks for answering

3

General Mach Discussion / Re: "run from here"

« on: January 22, 2011, 11:04:41 AM »

ok............I new, I suppose you mean my G code file.
here ya go......

4

General Mach Discussion / "run from here"

« on: January 22, 2011, 10:16:16 AM »

hey gang
Need some help.........
I have this program, an airfoil outline with some spar cut-outs.
It runs very smooth along the arc until I use the "run from here" option.
After that.........the arc is cut in jerky small steps. Nothing I can do changes this. Even ending out of Mach3 and reloading the G code , nothing helps. Its jerky steps from then on.
Someone help me here!!!
Pete in Lower/Slower Delaware