Hello Guest it is March 28, 2024, 07:42:38 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - LuAn

Pages: 1
1
General Mach Discussion / Re: Config Question
« on: January 23, 2011, 06:03:30 AM »
I'm not sure when it became available, but I'm using 3.042.036.

They are there in mine.  I think part of the reason I didn't notice them before is that they are already set to 0... so they don't make any difference with a laser (as others have now said).

2
General Mach Discussion / Re: Config Question
« on: January 21, 2011, 06:52:55 AM »
I'm using 3.042.020 so maybe that accounts for the difference.  It was working for me.  I was cutting paper and cereal packet card so it really doesn't take much to make a hole if there's any delay.

Will get myself into the habit of using M11P1 with a move in case I upgrade at some point.


@rrc1962: I looked under ports and pins but can't find a place to change that delay.  Again, this is probably to do with the fact that I'm running an old versions.

Hmm, maybe I should do that upgrade sooner rather than later.

3
General Mach Discussion / Re: Config Question
« on: January 20, 2011, 12:08:46 PM »
My thanks also to twehr for providing such a comprehensive explanation.

A small contribution from myself:

Even if you use M11P1 to turn the beam on, you can still use M5 to turn it off (because the delay occurs while the beam is off).  Less code to change (if you're doing it by hand) and no need for a move afterwards to activate it.  Stumbled across that realisation by accident when I left an M5 in.  ;-)

Pages: 1