Hello Guest it is February 27, 2024, 04:19:15 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - bobbya47

Pages: 1 2 3 4 5 6 7 8 9 10 »
General Mach Discussion / AXBB-E vs UC300ETH +UCBB
« on: October 14, 2020, 12:10:07 PM »
Which would you choose for mach3? They are both from CNC Drive.


General Mach Discussion / Motion Controller
« on: September 18, 2020, 12:25:44 PM »
I know there is been some discussion on the UC300 controller but I am having problems getting the motors to run on mach3. The inputs are all working properly so I know communication is working. I believe that I do not have the ports and pins configued properly. I set them like the manual showed. I am using xp. Can anyone tell me which port and pins I should be using? Any help would be appreciated. This is the usb controller.

General Mach Discussion / Re: Mach3 with windows 10
« on: August 24, 2020, 07:15:59 AM »
I am using an uc300. The problem now is mach3 will only open in demo mode. I downloaded mach3 and dropped my license file in but it still comes up in demo mode.

General Mach Discussion / Mach3 with windows 10
« on: August 21, 2020, 12:09:30 PM »
Is Mach 3 stable using windows 10?

General Mach Discussion / Re: Found my problem
« on: August 03, 2010, 01:21:46 PM »
No. It was connected to one of the power supply plugs. The cable was 18 ga shielded and about 4 ft. long. Since the PC was unaffected I am thinkng there could have been a minor voltage drop across the cable. The supply I used had a good solid 5v output and I mounted it in the control box with the breakout board.

General Mach Discussion / Found my problem
« on: August 03, 2010, 12:38:51 AM »
Quite some time ago I had a hard time getting my machine to run. Some might remember because I got a lot of help from forum members. I finally got it working but I still kept getting intermitent problems. I finally found the problem. I was using the 5volt supply from my computer power supply. It seems that there was a problem with the power supply. The voltage would intermitently drop to around 3 volts. Strangely enough the PC wasn't effected. I added an external supply and have not had a problem since.

General Mach Discussion / Re: Anybody got a number
« on: August 03, 2010, 12:31:48 AM »
I apologize if I was out of line.

General Mach Discussion / Re: Anybody got a number
« on: August 02, 2010, 11:38:02 PM »
I was just looking for a phone number.

General Mach Discussion / Re: Anybody got a number
« on: August 02, 2010, 07:14:01 PM »
Never mind. I filed a dispute with paypal and got their attention. Seems as if they have not shipped it. They said they would ship it today but I am not holding my breath.

General Mach Discussion / Anybody got a number
« on: August 02, 2010, 02:14:32 PM »
For Wildhorse Innovations? I ordered a probe over 2 weeks ago and have not gotten it. I sent a 4th email to them today and they do not even bother to reply. My credit card has been charged since 7/20. There is no phone number on their website.

Pages: 1 2 3 4 5 6 7 8 9 10 »