1
General Mach Discussion / Re: mach3 turn spindle dro not working, spindle speed changing while jogging
« on: April 14, 2011, 09:36:53 AM »
Dear Hood
You are so good to have stuck with me and I cannot thank you enough. The pressing of the mach spindle button did the trick.
I had wrongly assumed that this only applied when the spindle was under a speed control or via the program and since I only have the on/off lathe motor switch I never pressed it.
thanks now I can get on with some screwcutting
Cheers Geoff Ford Cape Town
You are so good to have stuck with me and I cannot thank you enough. The pressing of the mach spindle button did the trick.
I had wrongly assumed that this only applied when the spindle was under a speed control or via the program and since I only have the on/off lathe motor switch I never pressed it.
thanks now I can get on with some screwcutting
Cheers Geoff Ford Cape Town