Hello Guest it is December 01, 2021, 02:30:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dmetalcrafters

Pages: 1
1
General Mach Discussion / Re: Axis work in mill but not in plasma
« on: April 15, 2011, 01:02:07 PM »
may I ask what "xml" means?

2
General Mach Discussion / Axis work in mill but not in plasma
« on: April 14, 2011, 03:15:40 PM »
Hello all, I, like everyone else am new to this soft ware and can't seem to get it configured just right.
I have a hobby CNC kit and am trying to configure your software to it. The problem I'm having is when I'm in mill only two axis work, y and z, when I'm in plasma, only y and x work. I have the same settings in both mill and plasma but cant get all three axis to work. The machine is technically a 3 axis plasma but I'm so desperate to figure this out i was trying it in mill with the steppers not connected to anything. any advise would be appreciated.

3
Mach3 and G-Rex / Some axis work in mill, but not in plasma
« on: April 06, 2011, 09:44:50 AM »
I have some axis working in mill, but not in plasma. Mainly z axis.
any advise?

Pages: 1