Hello Guest it is March 28, 2024, 07:57:10 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - domenicxx

Pages: 1
1
General Mach Discussion / Re: Chinese CNCDIY 6040 Machine with Mach 3
« on: January 17, 2011, 05:58:13 AM »
Thank Rich

I will check tomorrow

regards

Domenic

2
General Mach Discussion / Chinese CNCDIY 6040 Machine with Mach 3
« on: January 17, 2011, 05:41:23 AM »
Hi

am having problems getting the installation with my cnc machine right

this may help someone to tell me what i am doing wrong

Spindle works fine
the  X Y Z stepper motors all work

except when i try and manually move using the jog interface the

X- and the X+   all work in the same direction ( to the right )
Z- and the Z+ all work in same direction ( down the table)
Y- and the Y+ dont work at all
I guess i am doing sometime wrong and very basically wrong

can anyone steer me in the right direction

take care
Domenic
Sydney/Australia

3
Hi

I am Domenic from Sydney/Australia

Just brought a cnc machine form China using Mach 3......  i am a bit confused but ok


Pages: 1