Guest
Show Posts
1
General Mach Discussion / On input signal estop?
« on: August 25, 2014, 03:34:51 PM »
Hello,
I have servo drivers who gives High signal on servo failure.
I have added that signal as input1 in Mach3.
Now I don't know how to configure Mach3 to go to estop when input High,
and maybe to display "servo failure". Just maybe.
Any help would be nice.
Thanks, Ivan
I have servo drivers who gives High signal on servo failure.
I have added that signal as input1 in Mach3.
Now I don't know how to configure Mach3 to go to estop when input High,
and maybe to display "servo failure". Just maybe.
Any help would be nice.
Thanks, Ivan