Hello Guest it is February 22, 2020, 05:40:40 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - machfab

Pages: 1 2 »
1
CVI MachStdMill (MSM) / Re: Not able to edit g-code file
« on: November 01, 2012, 04:38:19 PM »
I was waiting on the activation key for the MSM forum and decided to give this a try.

2
CVI MachStdMill (MSM) / Not able to edit g-code file
« on: November 01, 2012, 04:22:53 PM »
When trying to edit the current g-code file, I get "ERROR ON LINE 922 INTERNAL ERROR"
Any idea why this is happening?
Thanks in advance

3
General Mach Discussion / Re: dry run
« on: December 21, 2011, 06:48:03 PM »
I will try that! Thanks!!

4
General Mach Discussion / Re: dry run
« on: December 12, 2011, 06:15:35 AM »
Then just add a button to turn on a LED.  In your M codes for water and abrasive, look at that LED.
Could you expand on that? Would we modify the visual basic that operates the m codes? Would we add the button in the screen designer or will a hotkey turn on & off an led? Thanks

5
General Mach Discussion / Re: dry run
« on: December 11, 2011, 08:56:44 PM »
I am not sure if z inhibit will work as I only use x & y.

6
General Mach Discussion / dry run
« on: December 11, 2011, 07:37:15 PM »
Is there a way to "dry run" a program? Meaning run the g codes with the spindle (waterjet water) and coolant (abrasive flow) disabled?
Sometimes we need to trace cut the program once to make sure we have it positioned on the sheet correctly. Also is there a hotkey to turn on the spindle and a hotkey for the coolant? This would be handy for scrap cutting.
Thanks in advance.

7
General Mach Discussion / Re: Waterjet CV
« on: May 20, 2011, 09:51:18 AM »
Do you have to call up cv mode from the g-code or is it on all the time?

8
General Mach Discussion / Re: Feedhold
« on: May 20, 2011, 06:12:11 AM »
I will try that. Thanks for your help

9
General Mach Discussion / Re: Feedhold
« on: May 19, 2011, 08:00:36 PM »
Actually, after looking at it closer, it faults on rapid moves if I hit "stop". I am using the Machblue screenset. Just the drive or drives trip. Mach does not fault and has no message.

10
General Mach Discussion / Re: Feedhold
« on: May 19, 2011, 06:58:51 PM »
rapid is no problem only feedhold

Pages: 1 2 »