Messages

1

General Mach Discussion / Re: Welcome to the official Mach 2/3/4 support forum.

« on: December 16, 2010, 07:32:44 PM »

Dear Hood, I do not think Galil is working more than 2 axis so forget about Galil card. Do you have any other card can  work beautiful with March 3 to control Servo motors

2

General Mach Discussion / Re: Welcome to the official Mach 2/3/4 support forum.

« on: December 16, 2010, 07:13:42 PM »

Hello Hood,  If not all Galil board will work then never mind. Could you give me a specific board and instructions how to interface with the one you recommend, I will try. Thanks.  Another question is Instead of using the Fanuc control. Can Mach3 use with some motor drives to make an existing CNC machine to works ?

I later will post the Galil boards I still have in my company to see  I can savage these boards.

Best Regards

3

General Mach Discussion / Re: Welcome to the official Mach 2/3/4 support forum.

« on: December 16, 2010, 06:07:17 PM »

Thanks. I used the Galil control board. How can I interface between Galil board and software with Mach3 ? Does it have the instructions of interface  in manual ?l 

4

General Mach Discussion / Re: Welcome to the official Mach 2/3/4 support forum.

« on: December 16, 2010, 03:53:01 PM »

I am a new user of Mach 3. Could Mach 3 control Servo Motor ?

5

General Mach Discussion / Re: Welcome to the official Mach 2/3/4 support forum.

« on: December 16, 2010, 03:51:51 PM »

This forum is dedicated to Mach 2/3/4 support.

The new url is now www.machsupport.com/forum

I have backed up the database from the beta forum  but have descided that It might be an idea to start off fresh again.

I will over time merge some of the topics that had special interest in the previous forum.

This will hopefully be the last time you will need to relog in. I am sorry for this hassle.

There is currently only one section in this forum. Other sections will be added over time and upon general consensus