Hello Guest it is March 28, 2024, 06:35:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - crj1203ar

Pages: 1
1
General Mach Discussion / Program A axis to rotate as a Spindle
« on: June 10, 2011, 09:25:55 AM »
just added a 4 axis (" A axis" via a stepper motor to my system).  
I want to turn it on so that it continues to rotate at a constant speed while Mach3 runs my program (g-code) instead of having to
Program each line with the "A *********.*********" code" to have the A axis spindle.  
So how do I program the 4th axis to turn on at the beginning of my g-code file, then turn off at the end?

Any suggestions?  Thanks.

2
General Mach Discussion / Problem Loading Mach 3 in Windows 7
« on: December 12, 2010, 08:55:34 AM »
Hey everyone, I am having some problems


I try to run Mach3 with windows 7x64, but I cant get it show anything but a gray Screen.

when I Click on the Mach 3 "Mill" icon,  a message bar come up stating:

" Access to lasterrors.txt was denied"

Then the the MAch3 CNC controller comes up, but its just has a grey screen.

Any Ideas on how to correct this problem so Mach 3 Screens can be seen in Windows 7x64.
Thanks

Pages: 1