Hello Guest it is March 28, 2024, 10:35:03 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Araknid01

Pages: 1
1
General Mach Discussion / Re: New to mach3. Need help please.
« on: December 07, 2010, 11:52:04 AM »
Thanks all for the kind words. I already feel like I'm part of the family here.

What I've built is a laser cutter/engraver based off of the build on www.buildlog.com. Bart Dring's design. He has been more than helpful through the process.

My stepper setup is a three axis xyz configuration. Machine is now built and I'm needing to get the basic motor tuning setup. I'm running nema 17 motors through a geckodrive g540. Where do I start? Setting up home stops etc? Is there a video for this or can someone walk me through please.

Thanks in advance

Eric

2
General Mach Discussion / New to mach3. Need help please.
« on: December 06, 2010, 01:47:49 PM »
Is anyone here from the northern Virginia area?

I am building a laser cutter/engraver and am looking for someone near me that is experienced in initial setup.

Thanks in advance for a reply.

Eric

3
Is anyone here from the northern Virginia area?

I am building a laser cutter/engraver and am looking for someone near me that is experienced in initial setup.

Thanks in advance for a reply.

Eric

Pages: 1